Illuminated door sills are a modern upgrade for any car.

These led door sills are specially designed for your Lexus RX II 2003-2009 and are installed in the original mounting location.

Place for installation of this led door sill:

Material:
- High Quality Stainless Steel (main color: polished stainless steel),
- Acrylic Base,
- Double-Side Adhesive Tape.

Connection:

To correctly connect the LED door sills, the wires should be connected to a power source inside the door that is activated when the door is opened. This can be: the door switch, footwell lighting, door courtesy light, or any other power source that turns on when a specific door is opened.
Power supply 12V.

Important: with this type of connection, the door sills will only light up when the door is opened, which helps extend their service life.

The set includes 2 sills for the rear doors, all the necessary wiring, instructions for connecting.

Important: installation is carried out in the original plastic threshold; the plastic threshold body itself is not included in the kit.

Lightings.

We offer two lighting options.

The first option is the static type, this is the option when the backlight is made in one color (when ordering, you must select the appropriate lighting color 1 of 7).

The second backlight option is the flow type, this is the option when you will be able to set any color, change the brightness of the backlight, use dynamic effects. All lighting control will be carried out on your smartphone. It is more expensive, but you will get very great opportunities.

Installation:

1. Remove the original plastic housing where the illuminated trim panel is to be installed.
2. Carefully remove the part where you will be installing the illuminated trim panel.
3. Route the power cable of the new illuminated trim panel inside the plastic housing.
4. Remove the protective film from the back of the illuminated trim panel and carefully adhere it to the plastic housing.
5. Press the trim panel lengthwise with slight pressure to ensure a good seal between the adhesive tape and the plastic housing.
6. Do not wash the car in 24 hours.
7. Should be connected to +, - to the vehicle.

(For a correct connection, we recommend that you contact a specialist).

We can produce door sills with illumination with an individual logo. If you are interested in this offer, please contact us.

Development and production of OPdesign.

Production time: 10-12 days.

Warranty: 2 years.

Made in Ukraine (Europe).